PTEROFLAT XT PMMA
Material Safety Data Sheet
PTEROFLAT XT PMMA Material Safety Data Sheet
Solid Extruded PMMA sheet, produced by acrylic PMMA granules.
Veliköy O.S.B., Sanayi Bulvarı No:31 Kapı:3/A Çerkezköy/TEKİRDAĞ
PTEROFLAT XT is the brand name for extruded Polymethyl methacrylate (PMMA) sheets manufactured by POLITEM Dynamic Plastic.
No particular hazards know.
EMERGENCY AND FIRST AID INFORMATION
EYES: immediately flush with plenty of water. Get medical attention if irritation persists
INHALATION: remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
BURNS: flush the area with plenty of water. Remove contaminated clothing and shoes. Wash clothing before reuse. Get medical attention if irritation develops and persists.
Suitable Extinguishing Media: Water spray, foam, dry chemical, carbon dioxide Do Not Use: Full jet water Special Protective equipment for Fire-Fighting: Wear self-contained breathing apparatus.
Sweep or gather up material mechanically.
Avoid contact with eyes, skin and clothing. Wash thoroughly after handling. Keep container closed. Use only with adequate ventilation.
Avoid temperature extremes during storage; ambient temperature preferred.
No specific exposure related hazards are known. Wear protective gloves while handling sheets.
Change in Physical State Softening temperature about 102°C
Density (20°C) 1.19 g/cm³
Vapour Pressure Not applicable
Vicosity Not applicable
Solubility in Water Insoluble
pH value not applicable
Flash point 390°C (ASTM-D 1929-68)
Ignition Temperature 465°C (ASTM-D 1929-68)
Explosion Limits Not applicable
Thermal Decomposition About 280°C
Hazardous Decomposition With proper handling – none. On thermal decomposition vapours, consisting predominantly of Methylmethacrylate, are formed, which are inflammable and irritating to the eyes and respiratory system.
This material is chemically stable under normal and anticipated storage and handling conditions.
With proper handling and provided the standards of industrial hygiene and safety in the work place are followed, no health hazards should be expected.
PTEROFLAT XT PMMA is a solid material, insoluble in water and non-toxic, therefore no adverse effects on the environment should be expected.
RECYCLE AND DISCHARGE: The product is suitable for mechanical recycling. After appropriate treatment it can be remelted and processed into new molded articles.
Mechanical recycling is possible if the material has been selectively retrieved and carefully segregated according to type.
DOT HAZARD CLASS: Not regulated
PROPER SHIPPING NAME: Not regulated
IDENTIFICATION NUMBER: Not listed
OTHER INFORMATION: Not Dangerous Cargo. Keep Dry.
No labeling is required in accordance with the EEC directives. In connection with dusts formed in consequence of mechanical treatment, e.g. grinding, the appropriate regulation/maximal values for fine dusts must be observed:
MAX Value (fine dust): 6 mg/m3
This product does not contain reportable quantities of substances subject to supplier notification.
This information reflects current knowledge of POLITEM Dynamic Plastic. It serves to describe the product and cannot be interpreted as a guarantee of certain properties.